Prepregből autoklávban gyártott kompozit lemezek rétegközi tulajdonságainak alakulása a térhálósítás során alkalmazott technológiai paraméterek függvényében

Interlaminar properties of prepreg based autoclave cured composite plates depending on the technological parameters used in the curing process

Authors

  • Gergő Zsolt MARTON
  • Zoltán Tamás MEZEY
  • Gergely CZÉL

Keywords:

composite, prepreg, autoclave, cure cycle, interlaminar, properties, /, kompozit, autokláv, térhálósítási, térhálósítási ciklus, rétegközi tulajdonságok

Abstract

In this work, the effects of the heating rate, the amount of pressure applied to the composite during the cycle and the use of a temperature plateau have been investigated in the case of autoclave production of glass fibre/epoxy composite plates. Therefore, plates were manufactured using different parameters and then the fibre content, density and some mechanical properties were determined, with special emphasis on the interlaminar properties. The results of the tests were used to determine the consequences of deviations from the parameters recommended in the manufacturer’s technical data sheet.

Kivonat

Munkánk során a felfűtés sebességének, a ciklus során a kompozitra kifejtett nyomás mértékének, illetve a plató alkalmazásának hatásait vizsgáltuk üvegszál/epoxi kompozit lemezek autoklávos gyártása esetén. Ehhez különböző paraméterekkel állítottunk elő lemezeket, majd meghatároztuk ezek száltartalmát, sűrűségét és egyes mechanikai tulajdonságait, különös tekintettel a rétegközi tulajdonságokra. A vizsgálatok eredményei alapján elemeztük az adatlapon szereplő paraméterektől való eltérések következményeit.

References

Dong A., Zhao Y., Zhao X., Yu Q. Cure Cycle Optimization of Rapidly Cured Out-Of-Autoclave Composites. Materials. 2018, 11(3) 421.

Park S.Y., Choi C.H., Choi W.J., Hwang S.S. A Comparison of the Properties of Carbon Fiber Epoxy Composites Produced by Non-autoclave with Vacuum Bag Only Prepreg and Autoclave Process. Applied Composite Materials, 2019, 26, 187-204.

Marton G.Zs., Mezey Z.T. A technológiai paraméterek hatása a prepreg szerkezetek tulajdonságaira. Nemzetközi Gépészeti Konferencia–OGÉT, 2022, 182-186.

Olivier P., Cottu J.P., Ferret B. Effects of cure cycle pressure and voids on some mechanical properties of carbon/epoxy laminates. Composites, 1995, 26(7), 509-515.

Hu W, Centea T, Nutt S. Effects of material and process parameters on void evolution in unidirectional prepreg during vacuum bag-only cure. Journal of Composite Materials. 2020, 54(5), 633-645.

Adams D.F., Busse J.M. Suggested Modifications of the Short Beam Shear Test Method. in ‘Proceedings of the 49th International SAMPE Symposium. Long Beach, USA’ (2009).

Wisnom M.R. On the Increase in Fracture Energy with Thickness in Delamination of Unidirectional Glass Fibre-Epoxy with Cut Central Plies. Journal of Reinforced Plastics and Composites, 1992, 11(8), 897-909.

Downloads

Published

2024-04-23