Hengerfelülettel élezett egyenes fogú metszőkerekek klasszikus módszerrel való gyárthatóságának kérdései

On The Classic Manufacturing Possibilities Of The Right Teethed Shaper Cutter With Cylindrical Rake Face

Authors

  • Márton MÁTÉ
  • Dénes HOLLANDA

Keywords:

metszőkerék, homlokszög, henger-homlokfelület, köszörülés, profilhiba

Abstract

As well as known, the consequence of the classic sharpening of Fellows cutter results in an insufficient rake angle and theoretical profile error. If the common conical rake face is substituted with individual cylindrical surfaces, optimal rake angle values and theoretically perfect cutting profile is obtained. The tooth grinding can be performed here only with the use of a special profiled grinding wheel. The present paper shows that there exists such setting possibilities that allow the use of a classical biconic grinding wheel, by keeping the improved side rake angle values besides a minimal profile error.

Kivonat

Az egyenesfogú metszőkerekek klasszikus élezésének következménye a nem elégséges homlokszög és a profilhiba. A kúp-homlokfelület fogankénti hengerfelülettel való helyettesítésének következménye az optimális oldalhomlokszög-érték, és a nulla profilhiba, amennyiben a szerszám fogazatát speciális, görbe profilú köszörűtárcsával simítjuk. Jelen közleményben bizonyítjuk, hogy meg lehet találni azokat a beállításokat, melyek megengedik az egyenes profilú köszörűszerszám használatát, anélkül, hogy a profilhiba növekedne, vagy az oldalgeometria romlana.

 

Downloads

Published

2020-04-16

Issue

Section

D. szekció - Gépelemek, hajtások és tribológia